Levolor Cellular Shades - CAUTION: Bracket Mounting Surface

• Center the brackets on your marks, then mark each of the
screwholes.
— A minimum of 1
1
⁄4" flat vertical surface is required to
mount the brackets.
— The top of the installation brackets or extension brackets
should be at the desired shade height. The brackets
should be level and aligned.
— When using extension brackets, mark two screw holes
per bracket.
CAUTION: The rear of the brackets must be flush against a flat mounting
surface. Do not mount brackets on curved molding.
!
Headrail End Marks
Window Opening
2" Space Evenly Space Evenly
Motor
Side
2"
• With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 2 screws per bracket.
• Use a level to ensure all brackets are aligned.
• If more than two installation brackets come with your order, space additional bracket(s)
evenly between the two end brackets, no more than 30" apart, mark drill hole locations.
OUTSIDE MOUNT (OM)
INSTALLATION
12 Cellular Shades Motorized Control Lift