8. Lewmar limited warrant
KEY TERMS OF SUPPLY BY LEWM
R
Lewmar warrants that in normal usage and with proper maintenance its
products will conform with their specifi cation for a period of fi ve
ears
from the date of purchase b
ect to the conditions,
limitations and exceptions listed below. An
product, which proves to be
defective in normal usage during that fi ve-
ear period, will be repaired
r, at Lewmar’s option, replaced b
for the selection of products appropriate for the use
intended b
such selection.
iii Lewmar s
lication for which it was not desi
. a failure to service or maintain the
roduct in accordance with
modifi cation or alteration of the product;
f. con
uct’s performance specifi cations or
claim must be returned to the Lewmar
outlet which su
roduct for examination unless otherwise
, carriage, transport or insta
one other than authorised Lewmar representatives
unless it accords with Lewmar guidelines
nd standards of workmanshi
e marine
environment. Buyers inten
is limited to a period of one
f purchase by the end user in the case of any of the following products
draulic pumps, valves and actuator
Products used in “Grand Prix” racing application
:
a Lewmar shall not be liable for
Damages, costs or expenses pa
Lewmar’s negligence).
Some states and countries do not allow the exclusion or limitation of
es, so the above limitation or exclusion
e fi tness for purpose,
use, nature or satisfactory qua
i Where applicable law does not permit a statutor
to be excluded, then such warrant
’s law, shall be limited to a period of one
the end user. Some states and countries do not allo
imitations on how long an implied warrant
lasts, so this limitation
ou specifi c legal rights, and
also have other
legal rights, which var
, from state to state and countr
ean States a Consumer customer
and read in accordance with the laws
of England or the state or countr
in which the fi rst end user is domiciled
at the time of purchase of the product.
H DI
, TW20 8BF
7. Troubleshootin
e
This problem is a result of not securing the anchor rode combined
with the g
drive cap (22) being slack. Tighten the g
drive
cap using the tool provided and alwa
s secure the anchor rode
independentl
of the windlass whenever it is not being deplo
erate Troubleshoot Chart: Reversin
f no voltage is present, the batter
isolation switch is OFF, the
reaker is tripped or a fuse has blown. The batter
e across the motor leads with the windlass
on.
ow 11.0 V on a 12 V system
es, poor connections or corro
solation switch or solenoid. (Feel them to see if the
e correct? (Above 11.0 V and anchor is no
olt system is 13.5 volts. (Constant low voltage will destroy the
otor). Ensure that electrical cable size is lar
ithin acceptable limits. In an
circumstance voltage drop due
to cable resistance should not exceed 10%.