Lewmar V8 - 3.4 Model V9 fitting windlass

8
119 Nm
30°
3.4-1
3.4-3
119 Nm
3.4-4
Max 150mm
3.4-2
GB
3.4 Model V9 fitting windlass
• NOTE: Lewmar recommends V9 windlasses are specified and
installed by competent marine engineers.
• Using template drill 6 x 15mm diameter bolt holes.
• Cut 178mm and 140mm diameter holes.
• With a sandwich deck construction it is important to seal the exposed surfaces.
1. Fit studs to windlass base and tighten to 119Nm.
2. Measure deck depth plus deck backing plate and the 2 nuts and add 5mm. Trim studs to length, if required.
Maximum deck thickness 150mm.
• Apply a bead of suitable sealant/
bedding compound and mount the windlass through the deck.
3. Select the operating position for the band brake and insert bolts.
4. Assemble the deck backing plate and M14 nuts. Use Loctite® threadlock and torque to 119Nm.
Secure with M14 Nyloc nut.
NOTE: If using silicone or other rubbery type sealant, it is advisable to allow curing of the sealant before fi nal
tightening of the mounting nuts.
 WARNING! Extremely heavy,
use mechanical lift aid.
DO NOT use a permanent
adhesive/sealant, eg. 5200.