Lexicon
300 V 3.0 Owner's Manual
5-12
P224 DM:Clusters
EA:612 Chorus+EKOz EB:604 *3Voice Dlys
This preset is intended for “dual-mono” use. The LFO is set to a Triangle shape moving at 2.50Hz. The Soft knob changes
the spacing of the delays in Machine B. The Soft knob value is set to 20 when the setup is selected. This means that the
Soft knob can go down from its preset value if the application warrants it.
MchA EP:612 Chorus+EKOz Chorus+EKOz makes use of the flange gliding delay and several recurring echoes.
MchB EP:604 *3Voice Dlys Two taps (Delays 3 and 4 ) are set with delay ratios of 1:2, meaning that, when one is 200ms,
the other is 400ms, or when one is 359, the other is 718ms. This relationship is patched to the Soft knob parameter in Setup
Select mode.
P225 DM:2 Flanges
EA:606 OverTheTop2 EB:804 Sky Down
Two dual mono flange effects. This preset can work nicely with the same signal going to both Machines.
MchA EA:606 OverTheTop2 Similar to OverTheTop1, except the flange delay glides between 0.08 ms and 10.7ms. This
flange delay is patched to the LFO. The base delays are set to 10ms with a negative amplifier gain.
MchB EB:804 Sky Down This preset tunnels downward due to the liberal amount of delay feedback. If the effect is too
heavy, lower the feedback amount.
Cascade Setups and Their Effects
P301 CC:Rev ->*Dly
EA:701 Chamber EB:601*Dual Delays
This preset passes a reverb efffect into a delay effect with a delay Soft knob patch. As the Soft knob parameter is advanced,
the reverb will be delayed. If you modify the BMIX to some value less than its full wet preset value, an interesting pre-echo
effect will occur.
MchA EA:701 Chamber A great general purpose reverb tail. Size is set to 28.1M (the largest value is 64M), so the density
is rather close in. As you adjust Size, Rt will also change. If you want to unlink this natural phoenomena, set LINK to unlinl
(on Page Two).
MchB EB:601 *Dual Delays Baseline effect with the Soft knob parameter patched to the last two delay lines in the signal
path. Advancing the Soft knob parameter will cause the two post-delays to move in sync out to more than 2200ms.
P302 CC:*Dly ->*Rev
EA:601 *Dual Delays EB:714 *Joe’s B&G
Advance the Soft knob parameter, and the Machine A effect gets longer, and the reverb effect gets bigger. If you modify BMIX,
after advancing the Soft knob parameter, an even more distant echo effect can occur. Yeah, go ahead, give it a try!!!!
MchA EA:601 *Dual Delays Baseline effect with the Soft knob patched to the last two delay lines in the signal path.
Advancing the Soft knob parameter will cause the two post-delays to move in sync out to almost 3000ms.
MchB EB:714 *Joe’s B&G- Live performances in Joe’s 14.6M bar. Turn the Soft knob and the room size grows into a Bar
and Grill.
To Next Page
Loading...
