Lexicon 300 - V3.0 REV - Programming Parameter Glides

Lexicon
300 V3.0 Owner's Manual
6-6
Parameter glides can be a verypoweful feature. When you select a parameter
glide (PA,PB, or PS) as type of automation change, the display will update and
display three entries; Parameter Selection (RTIM, PDLY, DLY1,FBK1...), final
parameter value (12.5s, 125m, 225m, 45%...), and the frame duration (25Fr) of
the glide. The keys beneath each display entry allow you to select the function
for Soft knob programming of the parameter glides.
All parameter glides are based on the current Setup and effect which loaded.
Example:
Let’s say at the end of a scene, we want the Reverb Time to increase from its
preset value to 15 seconds. We want this glide to take 100 frames. At the same
time, we want the Input parameter to glide from its Setup value to OFF over the
same amount of time.
Suppose the current Setup and Effect is Dance Hall , then all of the parameters
in the Setup and effect can Be glided.
The Event List up to the glide might look something like this:
Programming
Parameter Glides
Edit #01 00 : 59 : 27 : 00
S: Large Hall
Edit #02 01 : 00 : 15 : 00
S: Dance Hall
Edit #03 01 : 00 : 21 : 07
**: New Event
You will need to make a copy of event 03 (because you want 2 parameter glides)
into the list, then edit both entries.