3-17
System Operation
Page Five
INS DEL ← ← → →
Current Setup Name
The bottom line of the display shows the name of the current setup, with a cursor
positioned under the first character. The two keys directly above the left and right
arrows cause the cursor to move left and right to select other characters.
Pressing the key directly above "INS" adds a blank space wherever the cursor
is currently positioned in the display. Pressing the key directly above "DEL"
removes the underscored character.
Turning the soft knob alters the underscored character. (Available characters
include: 0-9, a-z, A-Z, and an assortment of symbols.)
To rename the setup, simply position the cursor under the first character of the
current name, turn the softknob to replace this character with the first character
of the name you want, select the next character and change it, etc.
When you have made all the necessary changes to a setup and want to save it
in a register, press STORE. The display will show:
The top line of the display shows the source (Src) — the currently selected setup
name. The bottom line shows the destination (Dst) — the register number into
which the the setup will be copied. Use the Soft knob to select the register
number you want, then press STORE again. The display will return to the last
Setup Edit page.
Naming the Setup
Storing the Setup
Src: SET Large Hall
Dst: R# Available
Note: The 300 has a memory protection feature which enables or disables
copying into the registers. When Copy Tools are disabled, all storing
functions are inhibited. The Control mode Copy Tools page allows this
feature to beenabled or disabled. For more details, see the section
describing Control mode at the end of this chapter.
To Next Page
Loading...
