5-5
MIDI Operation
Each PCM 91 preset has a unique soft knob patch that allows you to control the
effect directly from Program or Register Banks mode with the ADJUST knob.
You can also control the soft knob patch remotely from MIDI, or from the Foot
Pedal.
To control the soft knob with MIDI, set Control mode 3.1 (Receive) to the desired
MIDI Channel. Set Control mode 3.5 (ADJUST) to the desired MIDI Controller
such as Mod Wheel.
Controlling the Soft
Knob with MIDI
MIDI ✱ADJUST
3.5 Send Mod Wheel
Now, the Mod Wheel on the MIDI instrument will control the soft knob patch of
the running effect.
Note: In Program Banks mode, the ADJUST display will not appear when the
controller is moved. In this case, ADJUST is still independent of the controller.
If you have a foot pedal connected to the PCM 91 rear panel Foot Controller jack,
you can use it to control the soft knob patch. (Note that no MIDI connections are
required to do this.)
Set both Control mode 3.5 ADJUST and Control mode 3.5 Foot Pedal to the
same MIDI Controller.
Controlling the Soft
Knob with a Foot Pedal
MIDI ✱ADJUST
3.5 Send Ctl 3
MIDI ✱Foot Pedal
3.5 Send Ctl 3
Now, the foot pedal will control the soft knob patch of the running effect. Keep
in mind that, if Patch Update (System 1.7) is set to Immediate, the current value
of the controller will be sent to ADJUST when the program is loaded. For
example, if your footpedal is at 0, ADJUST will be set to 0 on program load.
Note: Footswitches are transmitted with an On value of 127, and an Off value of
0.
To Next Page
Loading...
