Contents
Introduction
1. Product Overview
Block Diagram .................................................................................... 1-1
Front Panel Overview ......................................................................... 1-2
Rear Panel Overview.......................................................................... 1-3
Installation Notes ................................................................................ 1-4
Mounting ...................................................................................... 1-4
Power Requirements .................................................................... 1-4
Audio Connections ....................................................................... 1-4
Control Connections ..................................................................... 1-4
Setting Audio Levels .................................................................... 1-6
Headroom Display • Overload • Setting Input Levels
Setting Analog Output Level
Configurations .............................................................................. 1-8
Memory Cards.............................................................................. 1-9
2. Basic Operation
Modes of Operation ............................................................................ 2-1
Navigating a Matrix ...................................................................... 2-2
Info ............................................................................................... 2-3
History of Effects Loaded ............................................................. 2-3
Control Mode ...................................................................................... 2-4
Program and Register Banks............................................................ 2-17
Tempo Mode .................................................................................... 2-20
Editing an Effect................................................................................ 2-23
The Soft Knob ............................................................................ 2-23
The Soft Row ............................................................................. 2-24
Compare .................................................................................... 2-25
Bypass ....................................................................................... 2-25
Store operations ......................................................................... 2-26
Turning Memory Protection On • Storing an Effect
Renaming the Effect • Selecting a Bank and Register
Location
The Full Edit Matrix .................................................................... 2-28
Creating a Soft Row
Patching ..................................................................................... 2-31
About Sources • The Patch Row • Assigning a Source
Patch Sources • Assigning a Destination • Assigning
Values • Jump
Patching Examples .................................................................... 2-35
Creating a patch with default values • Adjusting the
modulation source parameters • Changing the default
destination values • Adding an additional pivot point to
the patch • Multiple Patches with the Same Destination
Mod Row Patches
The Custom Row ....................................................................... 2-42
Setting Range Limits for ADJUST and the Custom
Controls • Labeling ADJUST, the Custom Controls and Their
Ranges • Assigning KeyWords to an Effect
To Next Page
Loading...
