Lexicon
2-16
PCM 91 User Guide
Row 5
Mapx
Row 6
Chain
The PCM 91 has 10 internal program chains, numbered 0-9. (Ten additional
chains are available if a memory card is inserted.) Each chain is made up of 10
"links" (numbered 0-9). You can assign any program or register to any link in the
chain.
A chain can be loaded with a MIDI Program Change message, or by selecting
its number directly at Control mode 3.3. Once a chain is loaded, the source
assigned to Pgm+ and Pgm– will load the next higher or lower program in the
chain.
Pgm Assign
When Control mode 3.3 is set to Chain, received MIDI Program Change
messages will be mapped according to the selections made here. Two assign-
ments are available: MIDI Program Change # (0-127) and Chain # (0-9). When
the PCM 91 is shipped, all program numbers are mapped to Chain #0. To
change assignments, set Pgm#, with ADJUST, press Load/✱ to move the ✱ to
Chain# and set it with ADJUST. (You cannot assign more than one chain/MIDI
#.)
Chain Pgm Assign
Pgm# : ✱ 3 Chain# : 3
Chain 0-9
Use SELECT to choose a chain. Once a chain is selected, any PCM 91 program
or register can be assigned to any link in the chain. Press Load/✱ to move the
✱ from Link# to the Bank ID, to the program number. Depending on the field
marked with the ✱ , ADJUST will select link numbers 0-9, Banks (Pn or Rn), or
the desired program within the displayed bank.
Chain 3 Deep Blue
Link# : ✱ 0 P0 0.0
Map 0 and Map 1
When Control mode 3.3 is set to Map, received MIDI Program Change
messages will be mapped according to the selections made here. The selec-
tions available are: MIDI Program Change # (0-127), Bank # (PCM 91 preset,
register, or card bank) and Pgm # (PCM 91 effect number 0-49). When shipped,
the PCM 91 has the two internal maps configured to access all presets and
registers:
Map 0 Map 1
MIDI 0 = P0 0.0 MIDI 0 = P2 2.8
MIDI 127 = P2 2.7 MIDI 121 = P4 4.9
To Next Page
Loading...
