30 58D6056
PIL
OT
OFF
REMOT
E C
ONT
RO
L
Rock
Wool
INSTALLING CSDV40 LOGS IN FIREBOX (See Figure 39)
PILOT
OFF
REMOT
E CONTROL
Rear Log
Pins
Rear
Log (#1)
Left
Base
Log (#2)
Right
Base Log
(#3)
Top Left
Log (#4)
Top Right
Log (#5)
Pins
Pins
Top Mid Log
(#6)
Figure 39 - Installing Logs on Base (CSDV40)
Figure 40 - Installing Rock Wool (CSDV40)
LOG PLACEMENT AND ROCK WOOL PLACEMENT
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log (#1) on rear log pins.
4. Place left base log (#2) on the two pins against left side of firebox.
5. Place right base log (#3) on the two pins against right side of firebox.
6. Place top left log (#4) on left base log. Line up the notch in the bottom of the top log with the locator pins on the
bottom log.
7. Place top right log (#5) on right base log. Line up the notch in the bottom of the top log with the locator pins on the
bottom log.
8. Rest one end top mid log (#6) on left base log and the
other on front burner.
INSTALLING LOGS AND ROCK WOOL (EMBER
MATERIAL) IN FIREBOX
Break up rock wool (ember material) into dime-sized pieces.
Fluff up rock wool. Place rock wool evenly across both
burner surfaces. Do not block any areas around the perim-
eter of the burner, as these are the areas that supply the
needed air for secondary combustion. See Figure 40.
NOTE: Do not exceed one (1) layer of rock wool
coverage.
To Next Page
Loading...
