Installing the staple, hole punch finisher
CAUTION—TIPPING HAZARD: Installing one or more options on your printer or MFP may require a
caster base, furniture, or other feature to prevent instability causing possible injury. For more information
on supported configurations, see
www.lexmark.com/multifunctionprinters.
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet, and then from the printer.
3 Unpack the staple, hole punch
finisher.
4 Remove the printer top cover.
5 Install the finisher to the printer, and then push it down to make sure that it is securely attached to the printer.
Upgrading and migrating 314
To Next Page
Loading...
Need help?
General
