Using the EWS
1 Type the device IP address or hostname in the address field of your Web browser using the secure version of the
page (with the address beginning “https://”).
2 Use the navigation menu on the left to access configuration and report menus.
Note: If the device IP address or hostname is not readily apparent, you can find it by printing a network setup
page.
Printing a network setup page
1 From the home screen, touch Menus.
2 Touch Reports.
3 Touch Network Setup Page.
After the network setup page prints, the MFP will return to the home screen.
Settings for network-attached devices
After attaching the MFP to a network, you will need to configure additional settings. This section covers the basic
settings required for a network-attached device.
Creating and modifying digital certificates
Certificates are needed for domain controller verification, and for SSL support in LDAP. Each certificate must be in a
separate PEM (.cer) file.
Setting certificate defaults
The values entered here will be present in all new certificates generated in the Certificate Management task.
1 From the EWS, click Settings > Security > Certificate Management.
Note: For information about accessing the EWS, see “Using the Embedded Web Server” on page 15. Be sure to
disable HTTP and HTTPS access after you have finished using the EWS.
2 Select Set Certificate Defaults.
3 Enter values in the appropriate fields:
• Common Name—Type a name for the device.
Note: Leave this field blank to use the device hostname as the Common Name.
• Organization Name—Type the name of the company or organization issuing the certificate.
• Unit Name—Type the name of the unit within the company or organization issuing the certificate.
• Country Name—Type the country location for the company or organization issuing the certificate
(2-character maximum).
• Province Name—Type the name of the province where the company or organization issuing the certificate
is located.
Administering the device
16
To Next Page
Loading...
