The following illustrations show the most common lock port locations:
Encrypting the hard disk
Note: Not all devices have a hard disk installed. This section applies only to devices containing a hard disk.
If your MFP came with a hard disk installed, you must encrypt the hard disk. Hard disk encryption helps prevent the
loss of sensitive data in the event your MFP—or its hard disk—is stolen.
1 Turn off the MFP using the power switch.
2 Simultaneously press and hold the “2” and “6” keys on the numeric keypad while turning the device back on. It
takes approximately a minute to boot into the Configuration menu.
Once the MFP is fully powered up, the touch screen should display a list of functions, instead of standard home
screen icons such as Copy or Fax.
3 Verify that the MFP is in Configuration mode by locating the Exit Config Menu icon in the lower right corner of
the touch screen.
4 Scroll through the configuration menus to locate the Disk Encryption menu selection.
5 Select Disk Encryption.
6 From the Disk Encryption menu, select Enable.
Warning: Enabling disk encryption will erase the contents of the hard disk.
Overview and first steps
7
To Next Page
Loading...
