Overview and first steps
Overview
This guide describes how to configure a supported Lexmark
TM
multifunction printer (MFP) to reach Common Criteria
Evaluation Assurance Level 3 (EAL 3). It is critical that you carefully follow the instructions in this guide, as failure to
do so may result in a device that does not meet the requirements of the evaluation.
Using this guide
This guide is intended for use by Lexmark service providers, and network administrators responsible for the
management of security appliances and software in their network environment. A working knowledge of Lexmark
multifunction printers is required for effective use of this guide.
Some settings can be configured using either the Embedded Web Server (EWS), or the device touch screen. Where
applicable, instructions for both methods are included.
For information about physically setting up the MFP or using device features, see the User Guide that came with your
MFP. For information about using the MFP touch screen, see“Appendix A: Using the touch screen” on page 45.
Supported devices
This guide describes how to implement an evaluated configuration on the following models:
• Lexmark X463
• Lexmark X464
• Lexmark X466
• Lexmark X651
• Lexmark X652
• Lexmark X654
• Lexmark X656
• Lexmark X658
• Lexmark X734
• Lexmark X736
• Lexmark X738
• Lexmark X860
• Lexmark X862
• Lexmark X864
Operating environment
The instructions provided in this guide are based on the following assumptions:
• The MFP will be installed in a cooperative, non-hostile environment that is physically secure.
• The administration platform and local area network are physically and logically secure.
Overview and first steps
5
To Next Page
Loading...
