18
Understanding the control panel lights
Replace photoconductor (printer hard stop)
Programming engine code / Programming system
code
Light sequence:
• Continue—On
• Toner Low/Replace PC Kit—Blinking
• Error—Blinking
What this light sequence means:
The photoconductor kit is full and must be replaced. The printer
will not print any more pages until the photoconductor kit is
replaced.
What you can do:
• Press and release Continue to print a
photoconductor kit instruction page.
• Replace the photoconductor kit. (See Changing the
photoconductor kit on page 82 for help.)
Light sequence:
• Ready—On
• Toner Low/Replace PC Kit—On
• Load Paper—On
What this light sequence means:
New code is being programmed into the engine or firmware code
flash.
What you can do:
Wait for the message to clear. When the printer has finished
programming the code, it performs a soft reset.
To Next Page
Loading...
