4 Close the rear and front doors.
5 From the printer control panel, press to clear the message and continue printing.
202 paper jam messages
Error code Description Action
202.01 Exit sensor is covered during warm up. Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.03 Media did not reach the fuser exit sensor. Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.05 Exit sensor covered too long or exit sensor did not
clear ahead of a sheet.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.13 Restart attempted after an internal jam without cover
open. Close event. Likely that the jam was not actually
cleared.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.14 Expected banner sheet ( assumed wide ) not detected
by narrow media sensor, possible accordion jam,
unsupported narrow banner media, or missing signal.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.16 Page at fuser nip before fuser started ramping toward
desired. Indicates code may be receiving more hall
interrupts than intended.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser earlier
than expected, so it was probably staged.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then detected
speed was below threshold.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.28 Exit sensor bounce issue. Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
Go to
“Duplex service check” on page 57.
4514
Diagnostic information
53
To Next Page
Loading...
