Error code Description Action
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
Go to
“Duplex service check” on page 57.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
202.45 During warm up flush, sheet detected too long over
exit sensor.
Go to
“Sensor (fuser exit) jam service check” on
page 54.
Sensor (fuser exit) jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the fuser exit sensor cable JEXIT1 for proper connection.
Is it properly connected?
Go to step 3. Reseat the cable.
Step 3
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Exit
Does the sensor state on the control panel display change when it is
toggled?
Go to step 4. Replace the fuser. See
“Fuser removal” on
page 238.
Step 4
Check the fuser gears and rollers for damage.
Are they free of damage?
Go to step 5. Replace the fuser. See
“Fuser removal” on
page 238.
Step 5
Does the error remain?
Contact the next level
of support.
The problem is solved.
4514
Diagnostic information
54
To Next Page
Loading...
