Lexmark MS315 - Page 59

Error code Description Action
241.17 Page was not properly picked from tray 1. Have not
exhausted all pick retry attempts as there are sheets
committed to the paper path from below.
Go to
“Tray 1 jam service check” on page 60.
241.20 Took too long to ramp up media feeder motor in tray
1.
Go to
“Tray 1 jam service check” on page 60.
241.21 Media feeder motor stall in tray 1. Go to
“Tray 1 jam service check” on page 60.
241.22 Media feeder motor pick motor underspeed in tray
1.
Go to
“Tray 1 jam service check” on page 60.
241.24 Media feeder motor stalled on the last pick attempt
in tray 1.
Go to
“Tray 1 jam service check” on page 60.
241.32 Media tray not ready. Go to
“Tray 1 jam service check” on page 60.
241.33 The media tray was pulled during the media pick
process.
Go to
“Tray 1 jam service check” on page 60.
241.41 Media feeder motor stall in tray 1. Go to
“Tray 1 jam service check” on page 60.
241.42 Media feeder motor pick motor under‑speed in tray
1.
Go to
“Tray 1 jam service check” on page 60.
241.43 Media feeder motor stalled on the last pick attempt
in tray 1.
Go to
“Tray 1 jam service check” on page 60.
241.44 Motor 2 (Separator/Passthrough) motor stalled. Go to
“Tray 1 jam service check” on page 60.
241.45 Motor 2 (Separator/Passthrough) motor PWM
overflow error (underspeed). Motor underspeed
(max PWM and motor underspeed, typical
accordion jam).
Go to
“Tray 1 jam service check” on page 60.
241.46 Motor 2 (Separator/Passthrough) motor ramp (end
ramp - did not reach speed, typical pack feed paper
jam).
Go to
“Tray 1 jam service check” on page 60.
241.47 Motor 3 motor stalled. Go to
“Tray 1 jam service check” on page 60.
241.48 Motor 3 motor PWM overflow error (underspeed).
Motor underspeed (max PWM and motor
underspeed, typical accordion jam).
Go to
“Tray 1 jam service check” on page 60.
241.49 Motor 3 motor ramp (end ramp - did not reach
speed, typical pack feed paper jam).
Go to
“Tray 1 jam service check” on page 60.
4514
Diagnostic information
59