Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Delete fonts, macros, and other data stored in the
flash
memory.
From the printer control panel, navigate to:
> Settings > > Settings > > Print Settings > > Utilities Menu > > Format Flash
>
> Ye s >
• Use a larger‑capacity flash memory card.
Note: Downloaded fonts and macros that are not stored in the
flash
memory are deleted when the printer
is turned
o
or restarted.
Printer had to restart. Last job may be incomplete.
From the printer control panel, select Continue to clear the message and continue printing.
For more information, visit
http://support.lexmark.com or contact customer support.
Remove paper from standard output bin
Remove the paper stack from the standard bin.
Serial option [x] error [54]
Try one or more of the following:
• Make sure that the serial cable is properly connected and is the correct one for the serial port.
• Make sure that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly
on the printer and computer.
• From the printer control panel, press to continue printing.
• Turn o the printer, and then turn it back on.
SMTP server not set up. Contact system administrator.
From the printer control panel, press to clear the message.
Note: If the message appears again, then contact your system support person.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, press to confirm.
• Unplug the router, then wait for 30 seconds, and then plug it back again.
Troubleshooting 149
To Next Page
Loading...
Need help?
General
