132 errors
132 error messages
Error code Description Action
132.01 TDS baseline too low. Go to
“Toner density sensor service check” on
page 157.
132.02 TDS baseline too high.
132.03 TDS baseline excessive range.
132.16 TDS calibration at maximum.
132.17 TDS calibration too low.
132.18 TDS calibration too close to baseline.
132.32 PC drum measurement too high.
132.33 PC drum measurement too dierent from
calibration.
132.34 PC drum measurement too close to baseline.
Toner density sensor service check
Action Yes No
Step 1
Remove the transfer roll, and then check for loose toner blocking
the toner density sensor.
Is it free of loose toner?
Go to step 2. Clean the sensor.
Step 2
Check the TDS for proper operation:
a Lower the ACM assembly.
b Move the toner density sensor wiper from left to right.
Does it move freely?
Go to step 3. Reinstall the wiper
properly. If it still
cannot move freely,
then replace the
toner density sensor.
See
“Toner density
sensor removal” on
page 349.
Step 3
Check the cable JTDS for proper connection.
Is it properly connected?
Go to step 4. Reseat the cable.
Step 4
Check the cable JTDS for damage and pinch points.
Is it free of damage?
Replace the
controller board. See
“Controller board
removal” on
page 299.
Replace the toner
density sensor. See
“Toner density
sensor removal” on
page 349.
7015
Diagnostics and troubleshooting
157
To Next Page
Loading...
