Lexmark MX317 - Page 212

Actions Yes No
Step 9
Reset the address on the printer to match the IP address on the
driver.
Did this resolve the issue?
The problem is
solved.
Go to step 10.
Step 10
Have the network administrator verify that the printer and PC’s IP
address have identical subnet addresses.
Are the subnet addresses the same?
Go to step 12. Go to step 11.
Step 11
Using the subnet address supplied by the network administrator,
assign a unique IP address to the printer.
Note: The printer IP address should match the IP address on the
printer driver.
Did this fix the problem?
The problem is
solved.
Go to step 12.
Step 12
Is the device physically connected (Ethernet cable) to the network?
Go to step 13. Go to step 15.
Step 13
Try using a dierent Ethernet cable.
Did this fix the problem?
The problem is
solved.
Go to step 14.
Step 14
Have the network administrator check the network drop for activity.
Is the network drop functioning properly?
Replace the
controller board. See
“Controller board
removal” on
page 299.
Contact the network
administrator.
Step 15
Is the printer on the same wireless network as the other devices?
Go to step 17. Go to step 16.
Step 16
Assign the correct wireless network to the printer.
Did this fix the problem?
The problem is
solved.
Go to step 17.
Step 17
Are the other devices on the wireless network communicating
properly?
Go to step 18. Contact the network
administrator.
Step 18
Verify that the wireless card is properly seated on the controller
board.
Is the wireless card seated correctly?
Go to step 20. Go to step 19.
7015
Diagnostics and troubleshooting
212