MPF solenoid removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the screw (A).
A
3 Cut the cable, and then remove the solenoid.
4 Remove the rear cover. See “Rear door and cover removal” on page 273.
5 Remove the power supply. See “Power supply removal” on page 260.
6 Remove the duplex assembly. See “Duplex assembly removal” on page 262.
7 Release the cut cable.
Note: Pay attention to the cable route.
8 Open the controller board access cover, and then disconnect the cable.
7017-2xx, -4xx, -6xx
Parts removal
219
To Next Page
Loading...
