Installation note: Install the scanner rear covers first, and then the printer rear cover.
Rear door and cover removal
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
1 Remove the scanner rear covers. See “Scanner rear covers removal” on page 272.
2 Open the rear door.
3 Remove the two screws (A), and then release the latch on both sides of the cover (B).
B A B
4 Pull to remove the cover.
Sensor (bin full) removal
1 Remove the right cover. See “Right cover removal” on page 223.
2 Remove the left cover. See “Left cover removal” on page 209.
3 Remove the rear cover. See “Rear door and cover removal” on page 273.
7017-2xx, -4xx, -6xx
Parts removal
273
To Next Page
Loading...
