4 Turn the skew adjustment screw (B) appropriately ‑ clockwise for positive skew or counterclockwise for negative
skew.
Note: Do not remove the nuts or screws completely when performing the ADF skew adjustment (front side).
5 For negative skew, rotate the adjusting screw counterclockwise, as shown in the previous image.
6 After skew correction has been made, tighten the three nuts, and reinstall the ADF rear cover.
Note: Each full turn of the adjustment screw yields 0.3 mm of skew correction. The maximum adjustment is two full
turns either way.
ADF skew adjustment (back side)
1 Remove the ADF front cover. See “ADF front cover removal” on page 459.
2 Loosen the two screws (A) securing the adjusting bracket to the ADF frame.
7463
Repair information
288
To Next Page
Loading...
