Installation notes:
• When replacing the LVPS, ensure that all connections are replaced.
• When replacing the LVPS, ensure that the connector pins (D) properly engage the controller board.
Power switch removal
1 Remove the rear lower cover. See “Rear lower cover removal” on page 309.
2 Remove the right cover. See “Right cover removal (MX71x)” on page 311.
3 Remove the right frame extension. See “Right frame extension removal (MX81x)” on page 383.
4 Disconnect the main power cable (A) from the LVPS.
7463
Repair information
406
To Next Page
Loading...
