Check under the ADF tray
1 Remove the ADF tray.
2 Firmly grasp the paper on both sides, and then gently pull it out.
Note: Make sure all paper fragments are removed.
3 Reattach the ADF tray until it snaps into place.
4 Touch OK or press
OK
, depending on your printer model.
Paper or specialty media misfeeds
These are possible solutions if paper or specialty media misfeeds or skews, or if multiple sheets feed or stick together.
Try one or more of the following:
CHECK PAPER CONDITION
Use only new, unwrinkled paper.
Troubleshooting 140
To Next Page
Loading...
