196
Removing optional cards
4 Grasp the card and gently pull it straight up and out of the connector.
5 Place the option card in its original packaging. If you did not save the original packaging, wrap
it in paper and store it in a box for protection.
6 If you need to install another option card, refer to the Setup Guide. If not, reinstall the cover
plate.
7 Align the cover plate on inside surface of the slot.
8 Insert the two screws on the back of the printer so they pass through the cover plate and
tighten them.
9 See Reattaching the shield and closing the doors.
To Next Page
Loading...
