2-10 Service Manual
4412-00X
Scanner Motor with Gear Assembly Service Check
Motor will not run.
FRU Action
1 Scanner Motor with Gear
Assembly
Check scanner motor for shorts.
Disconnect connector P6 from the
system board and check for
approximately 6 ohms between the
following pins on the motor
connector.
P6-1 and P6-2
If the ohms reading is incorrect,
replace the scanner motor assembly.
If the motor does not come on during
the scanning process, check
connector P6 on the system board. If
the connection is okay, check for
voltage reading of approximately 29
volts at pins
P6-1
P6-2
P6-3
P6-4
If voltage is correct, replace the
scanner motor with gear assembly.
Go to the “Scanner Motor with
Gear Assembly Removal” on
page 4-9. If voltage is incorrect,
replace the system board. Go to the
“System Board Removal” on
page 4-19.
2 Document Scanner Sensor To check the document scanner
sensor, insert a sheet of paper or
press the sensor to see if the
scanner motor is working. Go to
“Operator Panel Problems” on
page 2-3.
To Next Page
Loading...
