4-20 Service Manual
4412-00X
Mid Frame Assembly with Exit Rollers Removal
1. Remove the top cover. See “Top Cover Assembly Removal”
on page 4-5.
2. Remove the carrier assembly.
3. Remove the maintenance station.
4. Remove the encoder strip.
5. Remove two screws from friction roller assembly.
6. Remove exit roller assembly.
7. Release four springs on small feed roller assembly.
8. Press down and remove each lower portion section of the small
feed roller assembly.
9. Release tabs in upper portion of small feed roller assembly.
10. Remove upper portion of small feed roller assembly.
11. Push up on mid frame assembly to release from large feed
roller.
12. Remove mid frame assembly.
To Next Page
Loading...
