4-12 Service Manual
4412-00X
Line Interface Board Removal
1. Remove the top cover assembly. See “Top Cover Assembly
Removal” on page 4-5.
2. Remove the one screw securing the ground wires to the
bracket.
3. Unplug the line interface connector from the line interface
board.
4. Remove the screw from the ground wire on the power supply.
5. Pull the snaps as shown to unlock the line interface board from
the system board. Push up on the line interface board.
6. Unplug all the connectors from the line interface board and
remove it.
To Next Page
Loading...
