Repair Information 4-15
4412-00X
8. Remove ground strap screw.
Note: When you reassemble the unit, do not pinch or short the wire
harness.
ASF Assembly Removal
1. Remove the top cover assembly. See “Top Cover Assembly
Removal” on page 4-5.
2. Remove paper support extension.
3. Release lower paper guide tabs.
4. Release upper paper guide tab.
5. Remove paper guide.
6. Remove paper deflector.
7. Release cables from guides located on ASF assembly.
8. Remove two screws.
9. Remove power supply. See“Power Supply Removal” on
page 4-11.
10. Remove the three screws from the ASF assembly.
To Next Page
Loading...
