Diagnostic Aids 3-5
4412-00X
CIS Test
The test adjusts the light of CIS. It is already set at CIS Test to get
optimum quality.
Warning: Shading profile must be made after downloading a new
firmware. If not, the system will not work properly.
1. Load all white document in scanner unit.
2. Press Setup and ‘CIS Test Press Start’ is displayed.
3. Press Start and ‘Shading...’ is displayed.
4. After scanning, shading waveform is printed.
5. After shading waveform has printed, press Stop.
6. Turn off system and turn on.
Aging Test
Scanner Aging - Scanner part aging
Printer Aging - Printer part aging.
Print Report
1. Press Setup.
2. Press Menu until ‘Print Report’ is displayed.
3. Press Options to select the log you want to print.
4. Press Start or Setup to print the report.
DTMF Test
ROM Test
Modem Speed Item
(1-6)
FSK/2400/4800/7200/
9600/112000/14400/
33600/12000/9600/
7200/4800/2400
33600 bps
Set TX Level (1-15) 12
Set RX Level (40-50) 43
Pause Time (1-9) 3
Setup Item Default
To Next Page
Loading...
