Lexmark X5470 - Can Send but Not Receive Faxes

3 Press or repeatedly until Tools appears.
4 Press .
5 Press or repeatedly until Device Setup appears.
6 Press .
7 Press or repeatedly until Country Code appears.
8 Press .
9 Press or repeatedly until the country or region where you are operating the printer appears.
10 Press to save the setting.
IS YOUR PRINTER MEMORY FULL?
Change the setting to Scan after Dial.
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 Press or repeatedly until Scan appears.
8 Press .
9 Press or repeatedly until After Dial appears.
10 Press .
Can send but not receive faxes
These are possible causes and solutions. Try one or more of the following:
LOAD PAPER
Load paper to print any faxes that have been stored in the printer.
CHECK THE AUTO ANSWER BUTTON
If the Auto Answer light is on:
• The printer will answer after the preset number of telephone rings.
• If you are using a distinctive ring, see “Setting the distinctive ring” on page 117.
CHECK INK
Check the ink levels, and install a new cartridge if necessary.
Troubleshooting
166