CHECK THE PAPER TYPE SETTING
Make sure the paper type setting matches the paper loaded in the tray:
1 From the printer control panel, check the Paper Type setting from the Paper menu.
2 Before sending the job to print, specify the correct type setting:
• For Windows users, specify the type from Print Properties.
• For Macintosh users, specify the type from the Print dialog.
CHECK THE PAPER
Avoid textured paper with rough finishes.
THE TONER MAY BE LOW
When 88 Cartridge low appears or when the print becomes faded, replace the print cartridge.
THE FUSER MAY BE WORN OR DEFECTIVE
Replace the fuser.
Repeating defects
REPEATING MARKS OCCUR EVENLY DOWN THE PAGE
Replace the charge rolls if the defects occur every 28.3 mm (1.11 in.).
Replace the transfer roller if the defects occur every 51.7 mm (2.04 in.).
Replace the print cartridge if the defects occur every:
• 47.8 mm (1.88 in.)
• 96.8 mm (3.81 in.)
Replace the fuser if the defects occur every:
• 88.0 mm (3.46 in.)
• 95.2 mm (3.75 in.)
Troubleshooting
286
To Next Page
Loading...
