Version 2.0.0 Page 9
3 Configuring the Basic MFP Settings
This section describes the process for using the information obtained in the Pre-Installation
Guide to configure the basic MFP Settings. Even if this device has been previously setup, follow
through these steps to make sure all settings necessary for the PKI capability to function
correctly have been configured.
3.1 Date and Time
In order to login in to perform a Kerberos login, the date and time must be within 5 minutes of
the date and time of the Domain Controller. The time can be set manually on the device or it can
be acquired from a time server.
1. Click Configuration and then click Set Date and Time.
To Next Page
Loading...
