Version 2.0.0 Page 1
1 Background Information
This document assumes you have read and completed the Pre-Installation Guide for the Lexmark
PKI-Enabled MFP. If not, please consult that guide before continuing with the installation.
Numerous mentions will be made throughout this document to the information that was gathered
using that document.
Before proceeding with the install, make sure the following has taken place:
1. The MFP has been unboxed and setup as according to the end-user manual.
2. The MFP has been assigned an IP Address and is connected to the LAN.
3. You can use the web browser to navigate to the MFP’s webpage. This can be done by
entering the MFP’s IP Address in the address bar of the web browser.
Once this has been verified for each MFP that will be PKI-enabled, you are ready to proceed.
To Next Page
Loading...
