Version 2.0.0 Page 24
The following table lists each setting and the corresponding Pre-Installation Section/Item that
contains the value needed for that field.
Setting Corresponding Pre-Installation Guide Section/Item
User Validation Mode
Section 3.2
DC Validation Mode
Section 3.2.2.1.1
OCSP Responder URL
Section 3.2.2.1.1 Item 1
The format should be http://<ipaddress>:<port>. Separate
multiple URLs with a comma.
OCSP Proxy URL
Section 3.2.2.1.1 Item 2
The format should be http://<ipaddress>:<port>. Only
one value is allowed.
OCSP Responder Certificate
Section 3.2.2.1.1 Item 4
OCSP Responder Timeout
Section 3.2.2.1.1 Item 3
Use MFP Kerberos Setup
Section 3.2.2 Item 2
If “One Kerberos Realm” is selected, uncheck this box;
the next three settings should be filled in. Otherwise,
check this box and the following three settings are not
needed.
Kerberos Realm
Section 3.2.2 Item 2
Kerbeos KDC
Section 3.2.2 Item 1
If there are multiple KDCs, enter them all here separated
by a comma.
Kerberos Domain
The default value of “mil,.mil” should be sufficient. If
Manual Login is allowed, other values may be needed
To Next Page
Loading...
