Lexmark X850E - Page 103

103
Attendance messages
52 Not enough free space
in flash memory for
resources
There is not enough space in the
flash memory to store the data
currently being downloaded.
Touch Continue to clear the message and
continue the print job.
Install flash memory with more storage capacity.
Download the data.
Touch Cancel Job to cancel the current job if
needed.
Touch Reset Active Bin to change to another
linked bin.
52 Unformatted flash
detected
The MFP detects unformatted flash
memory.
Touch Continue to clear the message and
continue printing. The MFP continues with
normal operations except for flash operations.
Reformat the flash to allow flash operations.
If the error message reappears, the flash
memory may be defective and require replacing.
54 Network [x] software
error
The MFP cannot establish
communications with a specified
installed network port. x indicates the
number of the specified port.
•Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
54 Serial option [x]
error
The MFP detects a serial error, such
as framing, parity, or overrun on the
specified optional serial port. x is the
number of the optional serial port.
• Make sure the serial link is set up correctly,
and the appropriate cable is in use.
• Make sure the serial interface parameters
(protocol, baud, parity, and data bits) are set
correctly on the printer and host computer.
•Touch Continue to clear the message and
continue processing the print job; however
the print job may not print correctly.
• Turn the MFP off and then on to reset it.
54 Standard network
software error
The MFP firmware detects an
installed network port, but cannot
establish communication with it.
•Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
55 Unsupported option in
slot [x]
The MFP detects an unsupported
option in the specified slot. x indicates
the number of the specified slot.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
56 Parallel port [x]
disabled
A status request occurs over the
parallel port, but the parallel port is
disabled.
Touch Continue. The MFP discards any data
received on the parallel port.
Touch Reset Active Bin to reset the active bin
for a linked set of bins.
56 Serial port [x]
disabled
The MFP receives data across a
serial port, but the port is disabled.
Touch Continue. The MFP discards any data
received on the serial port.
Touch Reset Active Bin to change to another
linked bin.
Message Meaning Action