Lexmark X850E - Page 104

104
Attendance messages
56 Standard USB port
disabled
The MFP receives data through a
USB port, but the USB port is
disabled.
Touch Continue. The printer discards any data
received through the USB port.
Make sure the USB Buffer menu item is not set
to Disabled.
Touch Reset Active Bin to change to another
linked bin.
56 USB port [x] disabled The MFP receives data through a
specified USB port, but this USB port
is disabled. x is the number of the
USB port.
Touch Continue. The MFP discards any data
received through the specified USB port.
Make sure the USB Buffer menu item is not set
to Disabled.
Touch Reset Active Bin to change to another
linked bin.
57 Configuration change,
some held jobs were lost
The MFP fails to restore held jobs due
to configuration changes. The
message appears once.
Some held jobs are not restored. They stay on
the hard disk and are inaccessible.
58 Too many disks
installed
The MFP detects an excess of hard
disks installed.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess hard disks.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
58 Too many flash
options installed
The MFP detects an excess of
optional flash memory cards installed.
Touch Continue to clear the message and
ignore the extra optional flash memory cards.
The message occurs again unless the excess
optional flash memory cards are removed.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess flash memory.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
58 Too many trays
attached
The MFP detects that too many
optional drawers and their matching
trays are installed.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the additional drawers.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
61 Remove defective disk The MFP detects a defective hard
disk.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the defective hard disk.
4 Install a new hard disk.
5 Connect the power cord to a properly
grounded outlet.
6 Turn the MFP on.
62 Disk full The MFP detects that there is not
enough memory or space on the hard
disk to store the data of the print job.
Touch Continue to clear the message and
continue processing the current print job. Any
information not previously stored on the hard
disk is deleted.
• Delete fonts, macros, and other data stored
on the hard disk.
• Install a hard disk with a larger memory
capacity.
Message Meaning Action