4 Flex the sheets or envelopes back and forth to loosen them, then fan them. Do not fold or crease the paper.
Straighten the edges on a level surface.
5 Load the paper or specialty media into the feeder.
Note: Make sure the paper is below the maximum fill line. Overloading may cause jams.
6 Slide the width guides until they lightly rest against the edge of the paper.
7 Set the Paper Size and Paper Type for the multipurpose feeder (MP Feeder Size and MP Feeder Type) to the correct
value for the print media you loaded. For more information, see “Setting the Paper Size and Paper Type” on
page 52.
Loading paper and specialty media
60
To Next Page
Loading...
