Lexmark X952 - Hole Punch to an Output bin

64
Tray Mapping 8 to Tray 1 Hp to IPDS Number 4.
(When IPDS Number 4 is the requested source in the IPDS data stream, pages are pulled from the printer
physical Tray 1 and all pages are hole punched.)
5.4.2 Hole Punch to an Output Bin
Hole punching may be performed on paper routed to most output bins which support hole punch. Hole
punching to an output bin is specified using the printer’s Option Card Menu > IPDS MENU > MAP
OUTPUT BINS menu. See MAP OUTPUT BINS Menu Options on page 36 for additional information.
A combination of the printer physical output bin and the IPDS data stream specified output bin is used to
specify hole punching.
Example 1 - To have
all pages
48
stacked in an output bin hole punched (Default settings are assumed in this
example. Check the finishing support table on page to determine the bins that support hole punch.)
To have
all pages
Output option Physical Bin 1
stacked in an output bin hole punched, specify the following in the IPDS MENU >
MAP OUTPUT BINS menu:
Output option Physical Bin 2
1. Select Bin Mapping 1
1. Select Bin Mapping 1
2. Select Output Bin 1 Hp
2. Select Output Bin 2 Hp
3. Select IPDS Number 1
3. Select IPDS Number 1
When the requested output bin number is 1 in the IPDS data stream, pages are hole punched and stacked in
the output option physical output bin selected.
Example 2 - To have
selected pages
48
stacked in an output bin hole punched (Default settings are assumed
in this example. Check the finishing support tables on page to determine the bins that support hole
punch.)
To have some
pages punched and some pages not punched
Output option Physical Bin 1
as they are stacked in the output option
physical output bin, specify the following in the IPDS MENU > MAP OUTPUT BINS menu:
Output option Physical Bin 2
1. Select Bin Mapping 1
1. Select Bin Mapping 1
2. Select Output Bin 1
2. Select Output Bin 2
3. Select IPDS Number 1
3. Select IPDS Number 1
4. Select Bin Mapping 4
4. Select Bin Mapping 4
5. Select Output Bin 1 Hp
5. Select Output Bin 2 Hp
6. Select IPDS Number 2
6. Select IPDS Number 2
Note: IPDS Number 1 is the default IPDS data stream output bin.
When IPDS Number 1 is the requested output bin in the IPDS data stream, pages are stacked in the output
option physical output bin and are not hole punched.
When IPDS Number 2 is the requested output bin in the IPDS data stream, pages are stacked in the output
option physical output bin and are hole punched.