EasyManua.ls Logo

Lexus is300 2021 - Disabling the TRAC System; Operating Conditions of Hill-Start Assist Control; The Secondary Collision Brake

Lexus is300 2021
436 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
239
4-5. Using the driving support systems
4
Driving
controlling the brakes, engine output
and steering assist.
The Secondary Collision Brake
When the SRS airbag sensor detects a
collision and the system operates, the
brakes and brake lights are automati-
cally controlled to reduce the vehicle
speed and help reduce the possibility
of further damage due to a secondary
collision.
When the TRAC/VSC systems are
operating
The slip indicator light will flash while the
TRAC/VSC systems are operating.
Disabling the TRAC system
If the vehicle gets stuck in mud, dirt or snow,
the TRAC system may reduce power from
the engine to the wheels. Pressing the
switch to turn the system off may make it
easier for you to rock the vehicle in order to
free it.
To turn the TRAC system off, quickly press
and release switch.
The “Traction Control Turned Off” will be
shown on the multi-information display.
Press the switch again to turn the sys-
tem back on.
Turning off both TRAC and VSC sys-
tems
To turn the TRAC and VSC systems off,
press and hold the switch for more
than 3 seconds while the vehicle is stopped.
The VSC OFF indicator light will come on
and the “Traction Control Turned Off” will
be shown on the multi-information display.
*
Press the switch again to turn the sys-
tem back on.
*
: Pre-collision brake assist and pre-colli-
sion braking will also be disabled. The
pre-collision system warning light will
come on and the message will be shown
on the multi-information display.
(P.179)
When the message is displayed on the
multi-information display showing that
TRAC has been disabled even if the
VSC OFF switch has not been pressed
TRAC is temporary deactivated. If the infor-
mation continues to show, contact your
Lexus dealer.
Operating conditions of hill-start assist
control
When the following four conditions are met,
the hill-start assist control will operate:
The shift lever is in a position other than P
or N (when starting off forward/back-
ward on an upward incline)
The vehicle is stopped
The accelerator pedal is not depressed
The parking brake is not engaged
Engine switch is turned to IGNITION
ON mode

Table of Contents

Related product manuals