277
5-5. Using the other interior features
5
Interior features
3 Within 1 minute of pressing the
HomeLink
®
button, after the
garage door operation has
stopped, press the “Learn” or
“Smart” button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that
2-way communication is enabled.
■ Reprogramming a single Home-
Link
®
button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1 With one hand, press and hold the
desired HomeLink
®
button.
2 When the HomeLink
®
indicator
starts flashing (orange), continue to
hold the HomeLink
®
button and
perform “Programming Home-
Link
®
” 1 (it takes 20 seconds for
the HomeLink
®
indicator to start
flashing).
■ Before programming
● Install a new battery in the transmitter.
● The battery side of the transmitter must
be pointed away from the HomeLink
®
.
Press the appropriate HomeLink
®
button. The HomeLink
®
indicator light
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
Closing
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
The indicators can operate within
approximately 820 ft. (250 m) of the
garage door. However, if there are
obstructions between the garage door
and the vehicle, such as houses and
trees, feedback signals from the
garage door may not be received.
Operating HomeLink
®
Color Status
Orange (flashing)
Currently open-
ing/closing
Green
Opening/closing has
completed
Red (flashing)
Feedback signals
cannot be received
To Next Page
Loading...
