427
6-3. Do-it-yourself maintenance
6
Maintenance and care
1 Park the vehicle in a safe place, turn
the engine switch off and wait 15
minutes or more.
2 Start the engine.
The ID code registration procedure cannot
be performed while the vehicle is moving.
3 Select on the center display.
4 Select “Vehicle customize”.
5 Select “Tire pressure”.
6 Check if the desired wheel set (“Set
1” or “Set 2”) is displayed.
ID codes will be registered to the displayed
wheel set.
To change the wheel set to be registered,
select the displayed set, and then select the
wheel set you wish to register.
If ID codes have already been registered
for that wheel set, the tire pressure warning
light will slowly blink 3 times, and a mes-
sage indicating that change is occurring
will be displayed on the multi-information
display.
7 Select “New tire registration”.
8 Select “Continue”.
The tire pressure warning light will slowly
blink 3 times and a message indicating that
ID code registration is being performed
will be displayed on the multi-information
display. Wheel set changing will be can-
celed and registration will begin.
When registration is being performed, the
tire pressure warning light will blink for
approximately 1 minute then illuminate and
“---” will be displayed for the inflation pres-
sure of each tire on the multi-information
display.
9 Drive straight (with occasional left
and right turns) at approximately
25 mph (40 km/h) or more for
approximately 10 to 30 minutes.
When registration is complete, the tire
pressure warning light will turn off and a
message indicating that registration has
been completed will be displayed on the
multi-information display.
Registration may take longer than normal
to complete if the vehicle speed cannot be
maintained at approximately 25 mph (40
km/h) or more. If registration cannot be
completed after driving for 1 hour or more,
perform the registration procedure again
from the beginning.
10 If the tire inflation pressure of the
wheel set installed differs from that
of the previous set, it will be neces-
sary to perform the tire inflation
pressure setting procedure of the
tire pressure warning system.
(P.425)
If the specified tire inflation pressure is the
same, it will not be necessary to perform
the tire inflation pressure setting proce-
dure.
■ When registering ID codes
● Normally, wheel position registration can
be completed within approximately 30
minutes.
To Next Page
Loading...
