123
3-2. Opening, closing and locking the doors
3
Operation of each component
NX200t_OM_USA_OM78145U
ON (operate) and OFF (stop) can be switched between by the “settings display”
(→P. 91) of the multi-information display.
Pressing or of the meter control switches (→P. 92), selects .
ON and OFF will be switched over with presses of on the meter control
switch.
When OFF is selected and the operations of the power back door is made to
stop, select and turn ON from the “settings display” of multi-informa-
tion display, and unless it is put in a system operating state, the operation of the
power back door will not return. (No return in the engine switch operation)
The open position of the power back door can be adjusted.
When setting with the switch
Stop the back door in the desirable position. (→P. 121, 122)
Press and hold the power back door
switch on the back door for 2 sec-
onds.
• When the settings are completed,
the buzzer sounds 4 times.
• When opening the back door the
next time, the back door will stop at
that position.
When setting by the navigation system
The opening position can be set with the navigation system. (→P. 644)
Priority for the stop position is given to the last position set by either the
switch or with navigation system.
To return the adjusted open position to the initial settings position. (→P. 125)
Canceling the power back door system (vehicles with a power back
door)
Adjusting the open position of the back door (vehicles with a power
back door)
To Next Page
Loading...
Need help?
General
