To prevent unintentional operation, turn the kick sensor operation setting off.
Open/close the back door using the kick sensor
WARNING
Observe the following precautions when operating the power back door.
● Check the safety of the surrounding area to make sure there are no obstacles or
anything that could cause any of your belongings to get caught.
● When putting your foot near the lower center part of the rear bumper and moving it
from the rear bumper, be careful not to touch the exhaust pipes until they have cooled
down sufficiently.
If the exhaust pipes are hot, they can cause burns.
● Do not operate the Hands Free Power Back Door if there is little space under the rear
bumper.
A
Kick sensor
B
Kick sensor detection area
C
Smart entry & start system operation detec-
tion area
1 While carrying an electronic key, stand with-
in the smart entry & start system operation
range, approximately 50 to 70 cm (19.7 to
27.6 in.) from the rear bumper.
2 Move your foot to approximately 10 cm (3.9
in.) from the rear bumper.
Operate the back door without contacting the
rear bumper with your foot.
3 When a buzzer sounds, move your foot back. A buzzer will sound and the
back door will automatically fully open or close.
● Perform the entire kick operation within 1 second.
● The back door will not start operating while a foot is detected under the rear
bumper.
● If another electronic key is in the cabin or luggage compartment, it may take slightly
longer than normal for the operation to occur.
● If the buzzer sounds twice, perform a kick operation again.
If a kick operation is performed while the power back door is operating, the power
back door will stop.
1-5. Entering/exiting the vehicle and loading luggage
159
1
Before driving
To Next Page
Loading...
