beams to flash or dazzle pedestrians or vehicles ahead. In such a case, it is necessary
to manually change between the high beams and low beams.
• When there are lights similar to headlights or tail lights in the surrounding area
• When headlights or tail lights of vehicles ahead are turned off, dirty, changing color,
or not aimed properly
• When the headlights are repeatedly changing between the high beams and low
beams.
• When use of the high beams is inappropriate or when the high beams may be
flashing or dazzling pedestrians or other drivers.
•
When the vehicle is used in an area in which vehicles travel on the opposite side
of the road of the country for which the vehicle was designed, for example using a
vehicle designed for right-hand traffic in a left-hand traffic area, or vice versa
•
When it is necessary to disable the system: → P.377
•
Situations in which the sensors may not operate properly: → P.382
■ Customization
The settings of some functions can be changed. → P.799
Turning the high beams on/off manually
■ Changing to the high beams
● Push the lever forward.
The AHS indicator will turn off and the high
beam indicator will turn on.
Pull the lever to its original position to enable the
Adaptive High-beam System again.
■ Changing to the low beams
● Press the Adaptive High-beam System switch.
The AHS indicator will turn off.
Press the switch to enable the Adaptive High-
beam System again.
3-1. Driving when the surrounding area is dark
239
3
Driving according to the conditions
To Next Page
Loading...
