Temporarily changing to the low beams
It is recommended to switch to the low beams when use of the high beams is
inappropriate or when the high beams may cause problems or distress to other
drivers or pedestrians nearby.
● Pull the lever rearward and then return it to its
original position.
The high beams will illuminate while the lever is
pulled, however, after the lever is returned to its
original position, the low beams will remain on for
a certain amount of time. After this, the Adaptive
High-beam System will operate.
AHB (Automatic High Beam)
The Automatic High Beam uses a front camera located on the upper portion of the
windshield to detect the brightness of the lights of vehicles ahead, streetlights, etc.,
and automatically changes the head lights between the high beams and low beams.
WARNING
■ For safe use
Do not overly rely on the Automatic High Beam. Always drive safely, taking care to
observe your surroundings and turning the high beams on or off manually if necessary.
■ To prevent unintentional operation of the Adaptive High-beam System
When it is necessary to disable the system: → P.377
Using the Automatic High Beam system
1 Press the Automatic High Beam switch.
3-1. Driving when the surrounding area is dark
240
To Next Page
Loading...
