Changing the pre-collision setting
● The pre-collision system can be enabled/disabled through a customize set-
ting.→ P.801
The system is enabled each time the power switch is turned to ON.
● When the system is disabled, the PCS warning light will illuminate and a mes-
sage will be displayed on the multi-information display.
● The pre-collision settings can be changed on the customize settings.→ P.801
● When the pre-collision warning timing is changed, the emergency steering
assist (excluding the active steering function) timing will also be changed. When
[Later] is selected, the emergency steering assist (excluding the active steering
function) will not operate in most cases.
When the dynamic radar cruise control is operating, the pre-collision warning
will operate at the [Earlier] timing, regardless of the user setting.
6-2. Using the safe driving support functions
407
6
Driving support system
To Next Page
Loading...
