The range of each detection area is:
A
Approximately 0.5 m (1.6 ft.) to 3.5 m (11.5 ft.) from either side of the vehicle
*2
B
Approximately 1 m (3.3 ft.) forward of the rear bumper
C
Approximately 3 m (9.8 ft.) from the rear bumper
D
Approximately 3 m (9.8 ft.) to 60 m (197 ft.) from the rear bumper
*3
Turning the Blind Spot Monitor system ON/OFF
The Blind Spot Monitor system can be changed between ON and OFF on the
center display
1 Select .
2 Select [Driving assist].
3 Select [Blind spot monitor].
When the BSM function is disabled, the driving assist infomation indicator illumi-
nates.
Each time the power switch is turned off then changed to ON, the Blind Spot
Monitor will be enabled automatically.
INFORMATION
■ The Blind Spot Monitor is operational when
The Blind Spot Monitor is operational when all of the following conditions are met:
● The Blind Spot Monitor is on.
● The vehicle speed is greater than approximately 10 km/h (7 mph).
● The shift position is in a position other than R.
*2 :
The area between the side of the vehicle and 0.5 m (1.6 ft.) from the side of the vehicle
cannot be detected.
*3 :
The greater the difference in speed between your vehicle and the detected vehicle
is, the farther away the vehicle will be detected, causing the outside rear view mirror
indicator to illuminate or flash.
6-2. Using the safe driving support functions
429
6
Driving support system
To Next Page
Loading...
